Recent content by olddog1

Wow. Super-nice job!!

No, I'm finished with it, Brett. Wearing it out now! Thanks for checking.

Well, here it is after some extensive cleaning, stripping and re-painting. The motor runs like a watch and after lubing it and attaching a new cord, I'm sure it'll live longer than I will. I replaced the two spindle bearings since one was squalling like a mashed cat and I'm sure the other...

Thank you! I appreciate it.

Not so far, but I only have about 30 minutes' time on it. I don't expect any problem with it. The two shafts are only about 3" tall and are secured with 3/8-16 nuts with thick area washers over and under the slots and the motor adjustment is original and pretty robust. It's hard to get it to...

Thank you. Those are really nice units but I just can't see spending a couple of thousand dollars for more equipment when I can get the desired result with equipment I already have, a couple of hundred bucks and a little shop time.

Thank you. That's good to know. Next time! That's a nice drill press!

Today I received the belt I needed to run this in the slowest position and the spindle speed is now 148 RPM according to my idiot-proof Starrett tach. It sawed a 2-1/2" hole in 7/32" steel without any hesitation whatsoever. I'm very happy with the result. It's not one the more sophisticated...

Thank you for the compliment! Where would I find such a motor?

:LOL:

Nice!

A great fix!

I'm just a home shop and for the amount of this work I do, what I did is plenty correct enough. Thanks for the input, though.

Thanks for the compliment. It was just a cast iron two-groove pulley with a 5/8 bore that had been in my pile of do-dads for decades. I just turned it down on the lathe to fit the inside of the column and ran a 5/8-18 bolt up through it to attach the pulley mount. Sometimes even a blind squirrel...

.