Building a buggy: nobggrnchvy
- Thread starter bggrnchvy
- Start date
Lot of small tasks, nothing major.
Engine wiring harness is in, only thing that needs to modded is the throttle body connector which I assumed since it's on the wrong side now.
Made a mount for the harness relay/fuse block even if half of the ciruits are dead/unecesary. I may unloom and depin all the extraneous **** when I tear it all down for paint...then again I might not:laughing:
Finally chucked up and turned down the 1350CVs for the 2-1/8" x 3/16" wall tube. They needs ~.020 turned off for a nice fit.
Started reassembling the front axle, it needs to go in for mockup one more time.
I had some concerns about getting any airflow through the oil cooler, so I modeled some scoops and printed them. After working out the protoype issues in PLA I did them in PETG. The center support interference isn't right and it cracked at the weakest point. I'm fixing that this morning hopefully.
Engine wiring harness is in, only thing that needs to modded is the throttle body connector which I assumed since it's on the wrong side now.
Made a mount for the harness relay/fuse block even if half of the ciruits are dead/unecesary. I may unloom and depin all the extraneous **** when I tear it all down for paint...then again I might not:laughing:
Finally chucked up and turned down the 1350CVs for the 2-1/8" x 3/16" wall tube. They needs ~.020 turned off for a nice fit.
Started reassembling the front axle, it needs to go in for mockup one more time.
I had some concerns about getting any airflow through the oil cooler, so I modeled some scoops and printed them. After working out the protoype issues in PLA I did them in PETG. The center support interference isn't right and it cracked at the weakest point. I'm fixing that this morning hopefully.